Magpul M-LOK Rail - 11 Slot, Polymer

9

| Write a Review

Ratings Snapshot

5.0

out of 5

5 (9)

4 (0)

3 (0)

2 (0)

1 (0)

Would recommend this product.

100%

SKU: MAG-593-BLK
UPC: 873750001241
Manufacturer: Magpul
MFG#: MAG593-BLK

It works like it should, m lok system is tight and easy to instal. This gives the ability to mount any 1913 accessories to your gun. Magpul always makes a great product; you can’t go wrong with this one.

Once again magpul delivers. I got the 11 slot polymer rail section just to see how good it is. So far I’ve been impressed and with the polymer costing less I see no reason to spend the extra money for aluminum.

The item is well made, and I am a huge fan of Magpul products. Too bad I wasn't getting it for myself.

Functionally nice for lightweight accessories, but I've found m-lok is certainly not the end-all "quick-installation" system. There are better systems out there, I wont mention names, but the locking tabs on the inside are a bit of a pain to get to turn correctly when tightening. Also most Magpul m-lock handguards are plastic, and overtightening can easily damage them, and I can easily see any accessory hanging off of handguards ripping this tiny lock right out of the guard.

This long m lok rail section looks excellent on my Mossberg 590A1 with the Magpul forend, and it was kind of difficult to put on, but I needed to get the right L wrench works excellent with my tactical gun light as well

This Magpul M-LOK rail section is doing the job and holding well. Well made and excellent finish. I do like the rounded corners. Screws come with thread lock on them, so you need to be careful when installing. You have to get each one started and set in its hole and then keep proper tension on them as you tighten them, keeping them fairly even. With the M-LOK, it's easy for the retaining bolt to slip up and nick or around the mount. Not my favorite platform, but hey, it's what SIG used, and this rail mounts to it well, be careful when installing. Once mounted, it stays very secure (I have a bipod on it) and seems sturdy. I prefer aluminum but I think this will hold up fine and might tighten down better. Made in USA too, bonus points for that Magpul. Only regret is I maybe should have bought a longer one, glad I didn't buy the shorter one.

This Magpul 11 slot Picatinny rail was easy to install (Of course) and feel and appear to be very durable. I bought this to mount a foregrip for my mother on the "barbeque" rifle, and she loves it lol

Functionally nice for lightweight accessories, but I've found m-lok is certainly not the end-all "quick-installation" system. There are better systems out there, I won't mention names, but the locking tabs on the inside are a bit of a pain to get to turn properly when tightening. Also, most Magpul m-lock handguards are plastic, and overtightening can easily damage them, and I can easily see any accessory hanging off of handguards ripping this tiny lock right out of the guard.

I mounted an AFG in my Ruger 10/22 Nylon stock, which fits great after I shave the back. For simple purposes, I just turned the nuts upside down to make the plain side contact the stock, thus avoiding the need to shave them-lok guides. Red threadlock was used since I want this rail as a permanent add on. I just wish Magpul to make longer sections, maybe 15 to 24 slots, so I could have mounted bipod and sling adaptor in the same rail. Rock-solid, won't hurt my stock more than the drilling and extremely affordable, thumbs up on these!!!