EGW Sight Mount For the Docter, Burris Fastfire, Vortex Venom, and Vortex Viper for Glock
Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.811"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw
Red Dot Fitment: Vortex Viper/Venom, Burris FastFire, Docter
This Evolution Gun Works mount fits all generation Glocks:
Tactical Solutions .22lr Conversion
Advantage Arms .22lr Conversion
Does not fit Glock MOS models.
Glock 17 Gen 4 MOS
Glock 19 Gen 4 MOS
Glock 34 Gen 4 MOS
Glock 40 Gen 4 MOS
Glock 41 Gen 4 MOS
Glock 35 Gen 4 MOS
Glock 34 Gen 5 MOS
Our Glock sights are meant to be installed from the left to the right. The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights
2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights
The screws that are included with this mount require a 5/64'' allen wrench for installation.
Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Customer Ratings & Reviews
Be the first to rate this item!Write Review