
EGW HD Savage Stealth Chassis - Round Back Short Action (Drilled for #8 Screws) Picatinny Rail Scope Mount with 20 MOA
Machined From: Solid 7075 T6 Aircraft Grade Aluminum
Finish: Matte Black Only
Compatible with Picatinny or Weaver scope rings.
Mounting Hardware: #8-40 X 1/4 Screws and T-10 Bit Included
Torque Specs: 20 in/lbs
Center Spread: 3.93"
Overall Length of Mount: 6.670"
Due to the change in which receivers have #6 and #8 screws from Savage, we recommend you remove and measure one of the screws prior to purchasing our scope mount. This will ensure that you receive the correct screws necessary for your specific application. If you have questions about your specific firearm, or need help regarding the specific screw size, you should contact Savage Customer Support at (413) 568-7001 or (800) 370-0708 and supply them with your serial number.
Rifles requiring #8 screws (please check your individual rifle to be sure):
- 10/110 BA Stealth
- 10/110 Stealth Evolution
- 110 Scout
- 110 Wolverine
- 10 GRS
- 110 Tactical
- 110 Tactical LH
- 110 Tactical Desert
- Christensen Arms Ridgeline - Based on Savage Action with Serial Numbers Starting With CB and Higher than CB00910
Screw Diameters
#6 Screws - .13" diameter
#8 Screws - .16" diameter
This will also fit the Savage 10 GRS
This base will fit the .308 and 6.5 Creedmoor - if you need a rail for the .338 Lapua please see the long action listing.
This Scope mounts is made specifically for the Savage Stealth Chassis gun that requires 8-40 screws which are included.
These scope mounts are now ambidextrous.
*The center spread is the distance between the two middle holes, center to center, on your receiver.
These bases sit at approximately 0.35” high.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002".
After machining; the mounts are tumbled and sand blasted. The aluminum mounts are Type III hard coat anodized for long lasting durability. The steel rails are Mil Spec parkerized for a durable rust resistant finish.
We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
Compatible with Picatinny or Weaver scope rings. Add EGW’s HD Scope Rings to make it a complete package!
From manufacturing to packaging, EGW’s products are made with pride in the USA.
Installation: EGW recommends 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).
Customer Ratings & Reviews
- 1
- 1