Burris 1/2-Inch Picatinny Riser

7

| Write a Review

Ratings Snapshot

4.7

out of 5

5 (5)

4 (2)

3 (0)

2 (0)

1 (0)

Would recommend this product.

100%

SKU: 126-BUR-410340
UPC: 000381103406
Manufacturer: Burris
MFG#: 410340

I stuck this on a Ruger charger 10/22 pistol to pick the red dot scope up a little, which worked just as it should. I didn't notice until I mounted it that the little vertical slit in the middle of the rail works a little like a small rear sight aperture which isn't bad in good daylight.

I bought these risers almost a year ago to accommodate a 44mm scope on top of an AR-15 rifle with medium height rings. After a couple of thousand rounds now, I have experienced no problems with them working loose or shifting back and forth. I have the risers mounted on a Stag upper currently. A friend that I frequently shoot with has these risers on his Bushmaster AR, he is running a 50mm scope on his rifle, and there is a 1/8inch of clearance to the foregrip. I have absolutely no problem with these risers, and if I were to need a new set on another rifle, I would buy these again.

It is very tight on dpms flattop but will go on if you take screws out and push hard. Excellent addition for Burris AR-P.E.P.R. 1-Piece Extended Scope Mount.

This 1/2 Picatinny riser worked great on my m4. By using the Allen wrench that came with the riser, you can torque the riser down onto the rail very tight. Just be careful placing the Allen wrench into the Allen screw very securely. I have always found Burris products to be above average in quality.

I went with the Burris brand on the picatinny riser even though there were a few cheaper options, not that the cost difference was big, but I wanted a decent brand name to go with. I'm glad I did cause it did precisely what I needed, and the quality of the material and the finish was excellent.

I purchase this Burris Picatinny riser strictly on the meat left in the on tension points compared to other brand options. I also chose based on the recessed heads of the Torx screws. Excellent product. Buy with confidence.

I've installed several different types of risers on various rifles. If you want a simple yet very secure 1/2" riser, this is the one to buy !!! The two torx head screws lock the riser securely into place, and there is no moving. This is very solid and should be able to withstand some heavy recoil.