Burris FastFire Mount
These Burris FastFire mounts allow any generation Burris FastFires red dot sight to be securely mounted on a specific firearm. Options are available for mounting to handguns, rifles, and shotguns, which each have different mounting requirements. Fits Vortex Venom, Viper, and Doctor Optic
Available Burris FastFire Mounts
410318 Ruger American Pistol
410319 All Glock & Beretta PX4 Storm
410321 1911 Standard
410322 1911 Adjustable/Novak
410323 Kimber Standard/Target/Bomar
410324 Beretta 92 & 96, 90-Two, Cougar, Taurus PT99 (does not fit M9A3)
410325 Beretta PX4 Storm (see 410319 for new mount)
410326 Glock (all models except .45 ACP/GAP and 10mm) (see 410319 for new mount)
410327 Sig Sauer P226
410328 Springfield XD
410329 Ruger Mark I,II,III
410332 Ruger M77, No. 1, Super Redhawk, Super Blackhawk Hunter
410333 Marlin 336, 444, 1895 (pre-drilled and tapped)
410334 Winchester M94 (pre-drilled and tapped)
410336 Smith & Wesson M&P
410635 Sako Rifles (requires Picatinny Mount)
The distinction between inferior quality and premium Fastfire mount or Vortex Venom Mount undeniable. At MSP, we only offer Mounts from the most trusted brands like Burris Optics. Buy with confidence that we stand behind the product we sell.
Customer Ratings & Reviews
Burris Fastfire Mount for 1911
I have a Para Expert 45 and a Colt 1991 Govt 9mm with the standard rear dovetail sight (not LPA or Novak). I bought 2 of the Burris 1911 mounts 410321. Each mount went on in less than 5 minutes including Loctite time. Went to the range, zeroed the red dots and checked the installation. Nothing loosened up or shifted. Have since shot a 2nd time and rechecked with the same result. Great product, easy, fast installation. Locator pins in the plate allow you to remove the red dot and reinstall without losing zero. This mount keeps your red dot as close to the slide as any other I've seen. If you don't want to cut your slide give these a try. I couldn't be happier.
This worked too well. Installed in 15 minuets!!
Burris Fastfire Dovetail Mount for Sig P226
Dovetail mount works as described. Did need to have rear sight pushed out by local gunsmith. Was not comfortable with tapping (hammering) our rear sight on my own without doing damage. Tapping rear mount into sight dovetail was relatively easy. I greased the dovetail and carefully put slide into vise with cloth protection. Be careful tapping dovetail mount into place with brass punch. Take it slow and be sure to center mount in dovetail. Once in place mount base for red dot attaches easily. Use blue loctite. On this Sig P226, once the Fastfire III was mounted, I did not have enough "up" elevation range to get the dot where it needed to be. Purchased a delrin shim from UM tactical for $9.95 to solve that problem.