Weaver Tactical 30MM Scope Rings - 6-Hole Picatinny

9

| Write a Review

Ratings Snapshot

4.7

out of 5

5 (6)

4 (3)

3 (0)

2 (0)

1 (0)

Would recommend this product.

100%

SKU: 105-WVR-9969X
Manufacturer: Weaver

I used these rings to mount a 50MM scope on my AR10, and they are both very easy to install and hold the scope tightly without damaging the tube. Even with some rough use, they have held the original zero. I consider them to be an excellent bargain and have two extra sets to use on future Picatinny rail rifles.

I mounted these weaver scope rings (extra high) on a DMPS LR308, and they quickly cleared a Zeiss with a 44mm objective. When the gun started throwing rounds, I took it to my gunsmith, thinking that the rings might be the cause. He checked them out and said that they were 100% true and aligned with the bore. Turned out to be an issue with the barrel. They helped me avoid a costly AR mount with integral rings. Just order extra hight and mount straight to the top rail.

I like the cross-bolt holding the scope rings to the base. These scope rings hold the scope so securely, and I see no slippage even on large magnums.

Well made 30mm scope rings that look great and hold scope securely. They were simple to mount with my Nikon M-223 scope on my AR15. The hardware looks rugged, and they are made in the USA.

These are very good scope rings. These Weaver 6 hole rings work great on Larger longer scopes on bigger caliber rifles. You needed to make sure you are using a Picatinny rail, These rings have a .187 bar, and will not work on the smaller weaver base.

good light rings , but strong, MSP good to trade with

I like the quality of the product and the fastners. Some rings you feel you have to be very careful not to cross-thread the hex-screws, but these go in smoothly, the holes between the upper and lower ring pieces are perfectly aligned. I especially like the wider style since my scope was being mounted on an M1-A/M14, which is famous for scopes going out of alignment from inferior mounts/rings. The redundant screws mean less cance for scope movement. These are great

Very good value for the money. I was looking for a good price as well as all screws had to be something other than Flat Head drive. I found that with these scope rings. I was very pleased with there fit and the price was very reasonable compared to any others I looked at. And I looked at nearly everything out there. I used these scope rings to mount my $1400.00 Nightforce scope. Very satisfied.

These are very nicely made and finished rings. I have them on a 12 gauge with a Ultradot sight. With these rings you don't have to worry about movement from recoil due to the great holding power of these rings. I have a true picatinny rail on my shotgun and these are true picatinny rings which allows no back and forth movement when mounted on the picatinny rail.