Weaver #92A Top Mount Bases for Thompson Center Contender
Each Weaver mount base is machined to tight tolerances for a custom fit. These Aluminum bases offer maximum strength for rings to hold tight
This silver one-piece base fits:
- Thompson Center Contender, G2 handgun & carbine rifle. a tactical multi slot base
- Rossi .410/.22 LR & .410/.17 HMR small frame matched pair for combos only
This scope mount will work with Weaver style scope rings.
105-WVR-48092 Gloss Black
This scope mount will work with weave style scope rings.
The distinction between inferior quality and premium Thompson Center mount is undeniable. At MSP, we only offer Scope Mount Bases from the most trusted brands like. Buy with confidence that we stand behind the product we sell.
Customer Ratings & Reviews
Mounted scope to my contender. Good quality, would buy again.
Contender scope mount
I've been using weaver bases on Contender barrels for years and, for the most part, have had no problems with them. With hard kicking calibers such as a 10 inch 44 Mag, it's hard to get the ring tightened enough to keep the ring from slipping on the base. If the ring slips, it will destroy the cross slots. If you are planning to scope a hard kicking Contender, then go with a steel base.
Mounted on a Rossi .17
They are mounted on a Rossi .17 HMR single Shot youth rifle. The Rossi single shots are drilled and tapped for the Thompson Center Contender base.
Weaver 92a scope mount
This is a scope mount that has gone "underrated" for years as a cheap way to get a scope mounted. I'm here to tell you that I couldn't believe the precision tolerances these bases have. I didn't think it until I got a scope ring alignment/ lapping tool. It was a real eye-opener for me. These are the only bases I will use on my Contender. Thanks
Rossi Scope Mount Base Kit
#92A Fits Rossi rimfire four-hole rounded receiver (is the larger amount shown in the picture). Comes with screws, use some blue Loctite. Remember that this is a weaver rail that fits the more commonly bought rifle scopes. This is not a 3/8" dovetail, which is the standard on air rifles and rimfires. Have yet to sight it in, but there is no reason this should not be a perfectly acceptable rail system.
TC Contender scope base
Have used it on a 7mm TCU pistol, 44 Magnum pistol, and now purchasing another for a 7-30 Waters in a carbine configuration. No shift due to considerable recoil, no deformation even though it is aluminum. Works well. I have a costly all steel base I'm scrapping. I thought if it was 4x more expensive, it must be better. Save yourself the problems aligning your scope. Get this one.
Thompson Center Contender scope mount
This is a product that has gone "underrated" for years as a cheap way to get a scope mounted. I'm here to tell you that I couldn't believe the precision tolerances these bases have. It was a real eye-opener for me. These are the only bases I will use on my Contender. Thanks
It was an easy mount. Removed rear sight and mounted to existing screw holes. Perfect fit.