Tactical Solutions Standard Ruger 10/22 Scope Mount

8

| Write a Review

Ratings Snapshot

4.5

out of 5

5 (6)

4 (1)

3 (0)

2 (1)

1 (0)

Would recommend this product.

100%

SKU: 222-TSO1022SCPRL-02
UPC: 856365001134

I took the original rail off my Ruger 10-22 and installed the Picatinny without any grief. It looks good. It has opened my options for mounted optics. I expect much better performance when all is said and done.

My Ruger 10/22 came with a Weaver scope mount. The problem was it was not compatible with my scope rings . This mount was a perfect fir for my 10/22 and also my scope .

I used this in conjunction with a set of Vortex Pro Series low rings to mount a Leupold 2-7x33mm scope to my rifle and could not be happier with how it turned out. This base is top quality, well machined and finished, and fit the rifle perfectly. Buy with confidence if you want a picatinny style base that is well made and won't break the bank.

I put these Picatinny rails on all My Ruger 10/22s. The Tactical Solutions version is the best. Perfect fit on the 10/22. The supplied screws are precisely the right length. I always use blue Loctite to make the installation permanent. Iron sights on the barrel are visible over this rail. I have severa. And will buy more in the future.

I first got a 10-22 takedown and a vortex venom 3moa red dot. The rail that came with the gun wouldn't work, so ordered this and it mounted right up and made for a nice setup. Ruger should just start packing rifles with a picatinny base rather than weaver but until then this is the part you need.

I put my 10/22 in a Tactical Solutions Vantage Ambidextrous Thumbhole Rifle Stock and put this Tactical Solutions 1-Piece Picatinny-Style Base on my rifle. The cheek rest on that stock is very high therefore I wanted to add an Leupold Mark 2 Integral Mounting System (IMS) 1-Piece Picatinny Style Mount to achieve the height I need to see through my scope. The spacing on the base will not accommodate the Leupold Mounting System. In my opinion, when Tactical Solutions makes a product and says it's picatinny style it should meet basic picatinny style specifications.

I used this to mount on my 10/22 to mount a primary arms micro dot, this mount is way better than the plastic ones and allows the use of the iron sights without a red dot on the rail. It was worth every penny, and i would not hesitate ti buy more if needed.

This is a nice looking and excellent fitting Picatinny rail for the 10/22. The screw holes of the base line up perfectly with the receiver. The only gripe I have concerns the 4 screws that are included with the base. They are regular flat head screws with very fine shallow slots and you have to be very gentle with them or you can deform the slots. Torx or Allen head screws would have been a better choice in my opinion.