EGW Sight Mount For the Vortex Razor for Sig P220-229, 320
Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.831"
Overall Width: 1.062"
Mounting Hardware: (2) 8-32 Button Head Screws, (1) 8-32 Set Screw)
Red Dot Fitment: Vortex Razor, C-More RTS & STS
This mount fits (including but not limited to):
Sig #8 Sights
Bersa Thunder UC Series (9/40/45)
Bersa Thunder HC Series (9/40/45)
This mount does not fit:
Any Optics Ready Sigs i.e. P226 Legion RX, P229 RX, P320 X-Carry etc.
P365 (The dovetail cut is too deep to work with our mount)
FN 509 Tactical
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. No alterations are required. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
The screws that are included with this mount require a 5/64'' allen wrench for installation.
Customer Ratings & Reviews
Be the first to rate this item!Write Review