Leupold Mark 2 IMS 30mm Integral Mounting System

9

| Write a Review

Ratings Snapshot

5.0

out of 5

5 (9)

4 (0)

3 (0)

2 (0)

1 (0)

Would recommend this product.

100%

SKU: LEU-110291
UPC: 030317102913

Fantastic mount! Works great on my Colt 6940, I have this mounted on my 3-9X Leupold VX-R Patrol Scope! I could not have asked for a better combination! A must-have mount!

Excellent quality Scope mount for a Leupold VXR 3x9 50mm on my Browning BAR Hog Stalker. Make sure you torque nuts @65 in/lbs and screws @28 in/pounds. I also used Loctite blue, which can't hurt. The Leupold 110291 is the Perfect height and alignment allowing fast target acquisition

I have always been a big fan of Leupold products and have owned several of their scopes and mounts. I recently purchased an AR10 and wanted to mount an illuminated Mil-dot scope. So I went with the Mark 4 3x9x30 and this mount. It all matched up perfectly and made for an easy install. Now if I can only find the time and range to dial it in.

Installed the 30mm version of this mount on a .308 AR. Torqued the screws per the instructions (mounting screws - 65 in-lb / ring screws - 28 in-lb). It is an excellent mount, and the Leupold scope I installed fit great. It puts the scope centerline 1.4 inches above the flat top rail. I have another rifle with a Rock River Arms one-piece mount. The RRA mount is super beefy, but it is taller (1.7 inches above the rail), and I need a stock riser to get in line with the scope. The Leupold IMS mount puts the scope at about the same height as regular AR iron sights.

I have both the 1" IMS and 30mm on different rifles. One a DPMS LR .308, the other an AR-15. Easy to install and position the scope properly. They stay tight — a better way to tighten it with a 1/2" socket. The Torx works; the socket is better. For quick removal, keep a 1/2" nut driver (these have a grip like a screwdriver) in your kit. I have another brand that has a different clamping method on another AR-15. Like this one better. Never disappointed with Leupold. Top-notch, highly recommended. Pros: easy install, positions scope properly, stays tight

This is just what I needed for my RRA Predator Pursuit rifle. I can mount the scope forward to achieve the proper eye relief as well as provide easy access to the charging handle. Set up was quick and easy, as well as rock-solid. I wish it had four screws per ring, but I admit the four total screws hold my Leupold VX-R scope with no movement. I definitely recommend this mount for scoped AR weapon systems.

I bought this to Leupold AR scope mount my Leupold Mark AR 3x9 on my Colt Le6920MPB. These mounts were quick and accurate to mount. Keep rock solid zero, and are not heavy or bulky on my AR as a lot of 1-piece mounts for ARs.

Mounted the Leupold mark 2 mount on My Windam Weaponry MPC, with A-2 front sight with a Leupold Mark AR Mod 1 scope. Solid mounting platform and this mount will give plenty height so crosshairs with not interfere from front sight on 1.5x, and you won't even see it on 4x.

After installing the Leupold Mark 2 ims on the Scout, it became apparent that the rifle points very well-scoped, thanks to this mount. No effort at all is getting a good sight picture. And, I don't have to remove the factory peep sight. It is good right where it is. Very happy with this mount.