My Cart: 0 item(s)
How to Clean Tekmat: Step-by-Step Guide to Keeping Your Mat in Top Shape
Tekmat gun cleaning mats are known for their durable construction, slick firearm schematics, and oil-resistant surfaces — but even the toughest mats need occasional cleaning. Whether you use your Tekmat for everyday pistol maintenance or deep rifle teardowns, keeping it clean helps extend its life and keep your workspace looking sharp.
Here’s how to clean your Tekmat properly without damaging the printed surface or losing performance.
🧽 Supplies You’ll Need
-
Mild dish soap (or gentle hand soap)
-
Warm water (not hot)
-
Soft sponge or microfiber cloth
-
Towel or drying rack
-
(Optional) Soft brush for stubborn grime
⚠️ Avoid bleach, harsh chemicals, or abrasive scrubbing tools. These can degrade the printed surface and rubber base over time.
🔧 How to Clean Tekmat – Step-by-Step
1. Shake or Dust Off Debris
Before washing, give your mat a quick shake outside to remove any dirt, dust, or gunpowder residue. Use a soft dry cloth to wipe off loose grime.
2. Prepare Soapy Water
Mix a few drops of mild soap in a sink or tub of warm water. Avoid using water that’s too hot, as it may affect the printed surface.
3. Wipe or Submerge
-
For light cleaning, dip a sponge or microfiber cloth in soapy water and gently clean the surface.
-
For deeper cleaning, submerge the entire mat in soapy water for 5–10 minutes, then lightly scrub.
4. Rinse Thoroughly
Use clean water to rinse off any remaining soap. Make sure there’s no detergent residue left behind — this can affect grip and smell over time.
5. Dry Flat
Use a towel to pat dry, then lay the mat flat to air dry. Do not wring it out or use a dryer — and avoid placing it in direct sunlight, which can fade the print.
🧠 Bonus Tips for Tekmat Maintenance
-
✅ Clean your Tekmat after especially greasy cleaning sessions.
-
✅ Store it flat or gently rolled to prevent creases.
-
✅ Never use brake cleaner, acetone, or abrasive solvents directly on the mat.
❓ Tekmat Cleaning FAQs
Q: Are Tekmat mats machine washable?
A: No. Machine washing or drying can warp the mat or damage the printed layer. Always hand-wash gently with mild soap.
Q: Can I use gun cleaner or CLP on the mat?
A: Tekmat mats are resistant to oil and solvent, but it’s best to wipe them off quickly. Prolonged exposure can degrade the print or rubber over time.
Q: Is it safe to scrub the mat if it’s really dirty?
A: Yes, but use a soft brush or sponge. Avoid steel wool or abrasive pads that could scratch the printed surface.
Q: How often should I clean my Tekmat?
A: It depends on use. Light users might clean once a month. If you’re doing frequent firearm maintenance, clean it every few sessions or when noticeably dirty.
Q: Will cleaning wear off the schematic print?
A: No — not if you use gentle cleaning methods. The print is bonded to the mat but can fade over time with excessive scrubbing or harsh chemicals.
✅ Keep Your Tekmat Looking Sharp
With just a little care and the right cleaning method, your Tekmat gun cleaning mat will last for years — looking great and performing like new. Whether you use it for your Glock, AR-15, AK, or 1911, it deserves a bit of upkeep.
Need a new mat or want to upgrade? 👉 Shop Tekmat Mats at Mounts Plus
