My Cart: 0 item(s)

- Step 1: Determine your pattern needed and use scissors or a utility knife to cut the rubber to your desired shape.
- Step 2: Clean the surface with included alcohol pad. Position the Wrapter material onto your desired surface.
- Step 3: Massage/knead material into place. Use a heat gun or blow dryer to warm the material. Do not overheat.
- Step 4: Press the material repeatedly working over the entire surface while the adhesive cools. The more handling, the better the adhesion.
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to - www.P65Warnings.ca.gov.
Customer Ratings & Reviews
Be the first to rate this item!
Write Review