Barrel Nut Torq Wrench for DPMS & KAC Rifles. This wrench allows the shooter to put the exact amount of pressure needed on the barrel nut while attaching the barrel to the receiver.
Constructed of 3/8 high strength steel with 4 lugs on each side to accommodate the DPMS and KAC barrel nuts. Works with any 3/8 or 1/2 drive torque wrench. The wrench was designed to accommodate DPMS barrel nuts that are a 24 hole pattern on a .845 Radius. The other side is for KAC 22 hole pattern on a .845 Radius.
This wrench will not remove DPMS Delta ring barrel nuts.
Be the first to rate this item!Write Review