A.R.M.S. #3 FN FAL Picatinny Rail Mount - Standard
The A.R.M.S. FN FAL standard and paratrooper are precision machined to military specifications. This FAL mount replaces the existing dust cover and offers the user a rigid mounting base with NATO standard weaver rail and Picatinny rails. This mount with fit L1A1 and FAL rifles. Manufactured from aluminum extrusions with steel attachment rails riveted in place. The exceptional rigid alloy body provides a rock solid platform for even the largest optics.
If you have a Paratrooper Model FN FAL Please see the A.R.M.S. #4
The distinction between inferior quality and premium Scope Mount is undeniable. At MSP, we only offer FAL Accessories from the most trusted brands like A.R.M.S. Mounts. Buy with confidence that we stand behind the product we sell.
Customer Ratings & Reviews
FN FAL Picatinny rail
I did have the DSA version but didn't like the mounting tabs that need tweaking all the time. The ARMS version has riveted full-length Picatinny rail, and the mount fits flush to the receiver, which is nice. Very sturdy, had to remove the rear tab for easier bolt carrier removal, but overall - great. Holds zero too.
A.R.M.S. #3 FN FAL Mount Standard
Nice mount exact and tight fit
They are great! I got exactly what I ordered and it arrived early. I called customer service and they were great in helping me get the right rail for my FAL.
A.R.M.S. #3 FN FAL Mount - Standard - Great product
Mount fits flawlessly on an L1A1 rifle (inch pattern FN FAL). Top quality, as you expect from A.R.M.S. mounting solutions. I prefer the simplicity of installation of this mount over the DSA solution with screws.
A.R.M.S. #3 FN FAL Mount - Standard
I have fitted this mount to my L1A1 inch-FAL (Enfield) and it works really well. It is a good interference fit and is just about removable by hand, without tools. Presumably this allows me to switch between scope & iron sights, but how much change results from removing / refitting the scope & mount assy, remains to be seen. As the accompanying instruction sheet states, the length may need minor adjustment to cope with variances between models; mine is actually about 20 thou short so no issues. The only issue I have with this specific item is that the l/h mount rail (these are riveted on) is not quite parallel with the mount body, resulting in the mount not perfectly aligning with receiver - if I was a US customer I would have probably have requested an exchange, as I'm in UK I'll live with it. Overall though it does the job well.
I have had other mounts before this by far is the best.
A lot of rounds and two years later....
These worked great at first. (I have two in use) Bought them about 1.5 years ago. Shot out to 600 yds with one rifle. But today I noticed point of impact shifts high then low then high. Upon inspection I found rivets in these both have become loose and mount has failed. This took about 5000 rounds in each rifle. Very disappointing.
So far I am very satisfied with this product. It fits nice and tight and does what it is supposed to.
Causes Ejection problems
I actually purchased mine several years ago. I had intermittant ejection problems right from the start with the ARMS mount installed. Reinstall the military cover and ejection problems go away. The ARMS port is too small! The brass hits the edges and bounces back into the chamber. They need to redesign and it would be top notch because it is really well made. I plan to take a dremmel tool to mine and open up the port
Fit perfectly on my L1A1 with no modifications. Factory dust cover pulled off easily and Standard mount slid into place with only light tapping with a hammer andsmall block of wood. New scope mounted securely and holds zero well.