My Cart: 0 item(s)
OverMolded Shotgun Stock & Forend Kit in High-Visibility Orange (12 Gauge)
When you need a shotgun that’s instantly recognizable, bright orange furniture makes the job simple—especially for dedicated training or agency setups where visual separation matters.
This kit pairs a matching stock and forend with Hogue’s OverMolded grip surface for confident handling, and it’s built for 12 gauge Mossberg 500-pattern pump guns listed below.
Fits these models (12 gauge)
- Mossberg 500
- 590A1
- 510 Mini
- Maverick 88
- Other Mossberg pump shotguns that are copies or variations of the 500
Does not fit
- 930 series or any other auto shotgun
- Break open guns
- Flex system shotguns
Before you buy (quick hardware notes)
These are the items that help prevent surprises during installation:
-
A flat washer must be used with the factory stock bolt, and a washer is included.
-
The stock is designed to reuse the factory stock bolt with the added flat washer.
-
If you’re switching from a pistol grip or Tamer setup to a buttstock, Hogue notes the correct stock bolt is not included and must be sourced separately.
-
A forend adapter nut may be required for some models (part #05020).
What’s included
-
OverMolded stock in orange
-
Matching OverMolded forend in orange
-
Flat washer (for use with the factory stock bolt)
Measurements
Stock
- Weight (with washer): 1 lb, 1.22 oz
- Length of pull: 14 in
- Recoil pad thickness: 1 in
- Stock drop: 1 1/2 in at front of comb (from barrel centerline), 2 1/2 in at heel
Forend
-
Weight: 5.17 oz
FAQ
What shotguns does this kit fit?
It’s listed for Mossberg 500, 590A1, 510 Mini, and Maverick 88 (12 gauge), plus other Mossberg pumps that are copies or variations of the 500.
Will it fit a Mossberg 930?
No. The page lists the 930 series and other auto shotguns as not compatible.
Do I have to use a washer with the stock bolt?
Yes. A flat washer must be used with the factory stock bolt, and a washer is included.
Is the stock bolt included?
Hogue notes the stock bolt is not included. The stock is intended to reuse the factory bolt with the included washer, and conversions from certain pistol grip setups may require sourcing the correct bolt.
Do I need a forend adapter nut?
Some models may require it. Hogue calls out adapter nut part #05020 as potentially needed.
What’s the length of pull?
The listed length of pull is 14 inches, and the recoil pad is 1 inch thick.
Is this kit for 12 gauge or 20 gauge?
This SKU is listed on the product page for 12 gauge versions of the compatible models.
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to - www.P65Warnings.ca.gov.
Customer Ratings & Reviews
Be the first to rate this item!
Write Review