3D Printed AR-15 Lower Offers Design Issues During Shooting


Shots have been discharged! Also with extraordinary investment, experts who are 3d printing devotees as well as 3d printing gun lovers are observing the most recent news on the Warfairy 3d printable AR-15 lower, with feature video explaining the procedures given by a user in Reddit  known as schlauncha.

It all started as soon as Warfairy released a 3d printable firearm plan on Reddit, which still obliged some conversion set and refinement. Known as the Hanuman AR-15 Bullpup, it requires users to use at their own risk and doesn’t have safety. The specs express that it ought to work without issue, however that was not the situation according to schlauncha.

In utilizing the open source design for the Warfairy Charon, schlauncha included some of his own changes, to include:

  • Beefed in advance takedown pin territory and jolt discharge pin zone.
  • 3d printing with ABS utilizing his Da Vinci Xyzprinter 1.0, expending nearly 1 spool of 600g.
  • Different and bigger buttpad for his fancied length of force.

Because of the extent of repercussion from the press against 3d printing of firearms, it is imperative to note that schlauncha stays in a place where it is lawful for him to 3d print the weapon, and also to have it.

“This gun fits in with all ATF standards like whatever other Ar15 lower,” brings up schlauncha.

Schlauncha experiences a few difficulties, however positive thinking rules with his task as he utilizes the ‘try again’ statement of purpose and continued refining and altering the 3d printed weapon with each one issue that products up. His first test was an attempt to open the cover tube which he estimated must have been pushed wrong or maybe he ‘thumped it’ as he ‘part it half through the trigger pin.’ In need of actetone to make a fix, schlauncha needed to hold off on discharging the firearm until the following day.

All things considered, the 3d printed firearm held out better than schlauncha had expected; notwithstanding, once the weapon was stuck back together, he noted some proceeding with issues: The gun still has some issues with failure to feed due to drag in the buffer tube, and after six shots it split vertically through the rear takedown pin. But, being 3D printed ABS, I believe I can just get some acetone down into that split and have it re-bond successfully.”

His last decision was that it was likely time to resign from this first model and proceed onward to another 3d printed correction. Talk about the process–and the issues Schlauncha experienced with his 3d printed firearm in the Modified Warfairy Charon forum.


Leave a Reply


Mounting Solutions Plus ©2016 All Rights Reserved (305) 253-8393,
10655 S.W. 185 Terrace Miami FL 33157