One of the most frustrating problems with reloading is
case failure. When the primer pocket becomes enlarged and will no longer hold
the primer, the case is useless. Some shooters are even glueing their primers
in with LOC-TITE! This is no longer a problem. By using the CASE SAVER, the
primer pocket can be re-swaged to form a ring, or “SEATING SEAL”
in the primer pocket.
Here is how it works:
1. The case is placed over the SUPPORT STAND.
2. The Guide Pin goes through the flash hole in the case and into the Guide
Hole in the top of the SUPPORT STAND.
3. Rap the punch LIGHTLY until the primer pocket grips the PUNCH. This indicates
the primer pocket diameter has been sufficiently reduced to allow a primer to
once again be held firmly in the case.
4. This process can be repeated as often as the primer becomes loose greatly
extending the life of the case.
SAVER SIZE CHART