Ruger Single Six Revolver Scope Mount by Weigand

Ruger Single Six Revolver Scope Mount by Weigand

Weigand Ruger Single Six revolver Scope Mount

Fits: RUGER Single Six, Single 9, Single 10 and Single Six .17 HMR scope mount

Finally a no drill and tap WEIG-A-TINNY style scope mount for the Single Six. This Single Six scope mount requires no drilling or tapping of your frame. Handsome, lightweight and durable. Blends beautifully with the lines of the Ruger frame. Accepts all Weaver and most Picatinny style rings and accessories. 4-1/2" long, available in black or silver, matte anodized finish, weighs 1.3 ounces.

This scope mount attaches to the rear sight elevation adjusting screw hole. You first remove the single six rear sight and replace it with our scope mount. Then insert the supplied screw into the elevation adjusting screw hole and tighten. In the front there is a nylon tipped set screw, that gets adjusted down just until it touches the top strap.* All of the testing of this mount was done with .22 Magnum without a single issue. We have sold hundreds of these mounts with tremendous success.

* Over tightening of the set screw can cause point of impact problems. It will cause the revolver to hit low.

.22 LR, .22 Magnum, .32 H&R Mag, .17 HMR

Color Finish:

(average out of 250 votes: 3.3 stars)

Customer Reviews

I was a little sceptical about a mount base with only one holding screw but this one seems to work fine on my 9 1/2" barrelled .22. I topped it with a smart looking weaver 1.5 -4 power , long eye relief 'scope . I have been getting many envious looks and comments at my local range these last few weeks william.. australia

MSP Code: 154-WC-RSSWM
Price: $34.95

Color Finish:
(average out of 250 votes: 3.3 stars)

You May Also Like
Runtime error in mm5/5.00/modules/util/smr_reviews.mvc @ [00000038:000001f8]: Line 3024: MvSMTP: 5.7.0 Must issue a STARTTLS command first. fo5sm16029913pbb.41 - gsmtp
©2015 Mounting Solutions Plus Inc. All Rights Reserved. Phone: 305-253-8393