The SureShell Polymer Carrier system, available in a six shell configuration, features shell holders injection molded from glass filled polymer, secured to the receiver by a lightweight aluminum back plate with brass threaded inserts. The new SureShell Polymer Carrier also includes an innovative dual rubber friction system that reliably holds shotshells in place. Models are available with and without integral Picatinny rails for mounting optics.
The principle difference between one model of SureShell and another, aside from capacity, is the light-weight aluminum backing plate, which is designed to mount the carrier assembly on a particular model of shotgun. Side-mount SureShell shotshell carriers for Mossberg , Remington and Benelli M1 shotguns use the trigger group pin holes to secure the assemblies to the weapon; the Benelli M2 Tactical, Benelli M4/M1014, Benelli SuperNova Tactical and some Mossberg 500/590 versions take advantage of the factory-tapped rail mounting holes in the tops of these shotguns and include integrated Pictanny optics mounting rails; another version with an integrated rail is the saddle-mount design for Remington.
Factory shotgun forends, except “tactical” forends, often feature significantreceiver overlap when the bolt is pulled back. These forends will need to be cut down or replaced with aftermarket “tactical” forends to be used with some SureShell shotshell carriers. Before you install a SureShell shotshell carrier, measure your forend’s receiver overlap and compare it to the furthest forward point of the shotshell carrier. Then cut any potential overlap or interference off the end of theforend with a miter saw or a rotary arm saw for a perfect fit.
The side mount system of our shotgun SureShell polymer shotshell carriers for the Mossberg 500/590 substitutes two custom-machined steel Chicago screws for the trigger pin. At the front of the mounting plate, custom retaining steel hardware is used with an elongated extractor screw and a machined key hole in the plate. The Mossberg 930 mounting system is similar, except it uses two sets of Chicago screws in place of the two trigger pins. The mounting plate was designed not to obscure the receiver serial number to make it easier for armorers to inventory their weapons.
SureShell aluminum shotshell carriers for the Mossberg fit on the left side of the receiver only. You must use a tactical forend that does not significantly overlap the receiver, or a factory forend that is cut down appropriately. SureFire forends will work fine with no alterations.
Be the first to rate this item!Write Review