Mesa Tactical SureShell Carrier for Remington 20-GA Shellholder

Mesa Tactical SureShell Carrier for Remington 20-GA Shellholder


SureShell shotshell carriers are available in three configurations: four-shell, six-shell and eight-shell. The six-shell and eight-shell configurations can be installed on the left side of the receiver, while the four-shell carriers can be installed on either side of the receiver. Carriers can also be installed pointed back toward the stock.

The principle difference between one model of SureShell and another, aside from capacity, is the backing plate, which is designed to mount the carrier assembly on a particular model of shotgun. Side-mount SureShell shotshell carriers for Mossberg , Remington and Benelli M1 shotguns use the trigger group pin holes to secure the assemblies to the weapon; the Benelli M2 Tactical, Benelli M4/M1014, Benelli SuperNova Tactical and some Mossberg 500/590 versions take advantage of the factory-tapped rail mounting holes in the tops of these shotguns and include integrated Pictanny optics mounting rails; another version with an integrated rail is the saddle-mount design for Remington; SureShell Carriers for M4 SOPMOD stocks feature special hardware for attachment to these buttstocks; Adapter Mount SureShell shotshell carriers are designed to be attached to Mesa Tactical Telescoping Stock Adapter accessory mount points.

SPECIFICATIONS Forend Compatibility Factory shotgun forends, except “tactical” forends, often feature significantreceiver overlap when the bolt is pulled back. These forends will need to be cut down or replaced with aftermarket “tactical” forends to be used with some SureShell shotshell carriers. Before you install a SureShell shotshell carrier, measure your forend’s receiver overlap and compare it to the furthest forward point of the shotshell carrier. Then cut any potential overlap or interference off the end of theforend with a miter saw or a rotary arm saw for a perfect fit.


The SureShell Aluminum Shotshell Carrier is available for the following 20 gauge shotgun platforms:
Remington 870, Remington 1100, Remington 11-87

Remington 870/1100/11-87

The Sureshell receiver mounting system for Remington 870, 1100 and 11-87 shotguns uses a combination of steel fasteners threaded into a steel pin (at the rear) and paired Chicago screws (up front) for more secure attachment to the shotgun without the risk of pinching the receiver. The mounting plate even features a window over the shotgun serial number location, to make it easier for armorers to inventory their weapons.

Note, SureShell aluminum shotshell carriers cannot be installed on right side of Remington semi-auto shotguns. To use a six- and eight-shot SureShell carrier mounted on the left side of the Remington 870 shotgun, you must use a tactical forend that does not overlap the receiver, or a factory forend that is cut down appropriately.

SureFire® forends are fully compatible with our six-shot SureShell carriers, but will need about ½ inch shaved off the end to be installed with Mesa Tactical eight-shot SureShell carriers. Remington side mount SureShell carriers are available in both 12 gauge and 20 gauge models. WARRANTY

Customer Ratings & Reviews

Be the first to rate this item!

Write Review
MSP Code: 133-MT-93260
UPC Code: 878405001324
Price: $79.95

Status: Status: In Stock, ready to ship
Not Yet Rated | Write the First Review

You May Also Like
Mounting Solutions Plus ©2016 All Rights Reserved (305) 253-8393,
10655 S.W. 185 Terrace Miami FL 33157