Weaver's precision-built steel bases are machined to tight tolerances for a custom fit. A square-cut notch mates to the sturdy cross bolt in every Weaver® top mount Ring. Custom-hardened fastening screws included
Rear base for:
Front base for:
Note: Savage 10, 12 & 16 - short actions. Striker, Pistol, 510, 512, 516 S/A, 10 ML - 2-piece only pre 2003 models - for shorter tube scopes or red dot scopes use #402 extension front base or one-piece base if available. Extension base allows an extra .689"
Note: Savage / Stevens 200 - for shorter tube scopes or red dot scopes use #402 extension front base or one-piece base if available. Extension base allows an extra .689"
Note: For the Mauser Receiver Ring with about 1.410" diameter - 98FN and the Receiver Ring about 1.300" diameter (Swedish 96) shimming is probably required for perfect scope alignment. The rear base may require modifications for correct fit to military actions
Note: For the Winchester 52 with the hole spacing the same; may require bolt and/or safety alteration, otherwise firearm cannot function safely and properly. Consult with a qualified gunsmith
Note: The handiest way to pinpoint the correct base for the Winchester 52 & Winchester 70 Long action Rifles is to check the spacing of the tapped holes for the rear base and compare it to the hole spacing for the front base.
If the hole spacing is the same, then for model 52 use 46+ 46 and for model 52 use 25+ 57.
If the hole spacing is different, then for model 70 use 47+ 46 and for model 70 use 49A+ 46
This scope mount will work with Weaver style scope rings.
Color Mount:
105-WVR-48227 Matte Black
Be the first to rate this item!
Write Review